Hello everybody  
 
I'm using Stitcher 5.0.2. and Quicktime 7
 
When I stitch a panorama and I render it immediately in QTVR with hotspots, I have no problem.
But, most of the time, I wan't to export them in Photoshop to apply filter for example. The problem is : when I re-import the PSD file in Stitcher to convert it in QTVR with hotspot, Stitcher refuse to render it with this message : error when tryng to write the file. Verify that Quicktime player is not open (0). Of course : the Quick time player is not open, I don't use the default codec, my hard disk is not fragmented, etc. as say in the Stitcher documentation.  
When I convert this panoramas in QTVR without hotspots, I've got no problem.  
 
What's wrong, please !  
 
GiLd

Hi GiLd!
 
This error message will crop up when you "open" a file directly... you need to use the "Load Panorama" command to load the previously rendered pano.
 
In addition you must have saved a "hotspots" file from the original Sticher project (or add them in the pano conversion process). After using the "Load Panorama" command you can then load the hotspots into the pano from the hotspots file you previously saved. Page 108 of the printed manual has all the details of this operation.

Hello Jim  
 
Thanks for your answer  
 
Well in fact I use the "load panorama" fonction to import a panorama, as written in the manual.  
 
But  I didn't try to create a hotspot in the original Stitcher project, then load it after loading panorama. I try this  
 
Thanks :  
 
GiLd