Hi everyone,    
 
I'm having problem with Guiding line.
After placing about 8 markers I get a message which states that the caliberation process was completed. While all the markers and pictures do turn green,then I add locators for modeling,I create a marker in the first image, the Guiding Lines are displayed in the other shots in the viewport,then I slide the pointer along the Guiding Line,but I found the position where I want to place is not on the Guiding line,(far from the Guiding line),what shoule I do now?
 
Thank you,
Wenz

Hello Wenz,
 
  If the calibration is correct, the guiding line should pass through the "real" point in other shots ...
Does it pass away from real point only in the magnifier or also in the 3dview ?
If only the magnifier fails, it might be because a high distortion was found.
 
In any case, place always the points at the right place in image, even if slightly away from line.
 
 
Best,
 
Stef